SDS- Truly Premium Advance Auto Wash

Safety Data Sheet

Section 1. Identification

Mailing Location:

PO Box 2465

Saint Leo, FL 33574

EMERGENCY TELEPHONE NUMBER

24-Hour Emergency Contact: CHEMTREC +1 800-424-9300

Product Identification: Undisputed Quick Detailer

Suggested Use: To clean interior and exterior of vehicles.

Section 2. Hazard(s) Identification

Physical hazards

Not classified.

Health hazards

Suggested to avoid eye contact.

Environmental hazards

Not Classified

Label elements

NONE

Signal word None

Prevention: Do not touch eyes while handling and rinse from hands after use.

Response

If in eyes: Rinse for several minutes with water, remove contact lenses, if present and easy to do. Continue rinsing. If eye irritation persists: Get emergency medical help.

If Skin Irritation Occurs: Seek medical attention.

Disposal Dispose of contents/container in accordance with local/regional/national/international regulations.

Section 3. Composition/Information on Ingredients

Component Name

Non-Hazardous blend/Below reportable levels

CAS Number

N/A

EC Number

N/A

Percentage

Trade Secret

The chemical percentage for the raw materials in this product are below the value needed for hazardous classification.

Section 4. First Aid Measures

Eyes: Flood with large amounts water at least 20 min.; get immediate medical attention if irritation persists. Can cause irritation, redness, tearing, and blurred vision.

Skin: Flush exposed area with water. Remove all contaminated clothing. Prolonged or repeated contact can cause moderate irritation.

Inhalation: If affected, remove individual to fresh air. If breathing is difficult, administer oxygen. If breathing has stopped, give artificial respiration. Keep person warm, calm, and get medical attention.

Oral: If swallowed, Do Not induce vomiting. Get medical attention if symptoms occur and persist.

Section 5. Fire Fighting Measures

Extinguishing media

Suitable extinguishing media: Water spray. Alcohol-resistant foam. Carbon dioxide (CO2). Dry chemical. Unsuitable extinguishing media: None known..

Special hazards arising from the substance or mixture

Hazardous combustion products: Nitrogen oxides (NOx). Silicon oxides. Carbon oxides. Chlorine compounds.

Unusual Fire and Explosion Hazards: Exposure to combustion products may be a hazard to

health.. Fire burns more vigorously than would be expected..

Advice for firefighters

Autoignition Temperature: Not applicable

Flammability Limits in Air: Not Applicable

Fire Fighting Procedures: Fire residues and contaminated fire extinguishing water must be disposed of in accordance with local regulations.. Use extinguishing measures that are appropriate to local circumstances and the surrounding environment.

Section 6. Accidental Release Measures

Containment/Clean Up: Sections 13 and 15 of this MSDS provide information regarding certain Federal and local requirements. Collect for disposal. Clean up remaining materials from spill with suitable absorbent. For large spills provide diking or other appropriate containment to keep material from spreading. If diked material can be pumped, store recovered material in appropriate container. Clean area as appropriate as some silicone material, even in small quantities, may present a slip hazard. Final cleaning may require steam, solvents or detergents. Observe all personal protection equipment recommendations described in Sections 5 and 8 of this MSDS. Observe all Federal and government regulations that may apply to the cleanup of this material.

Section 7: Handling and Storage

Handling: Wear personal protection equipment. Avoid contact with eyes, skin and clothing. Avoid ingestion and inhalation. Ground and bond containers when transferring material to avoid static discharges. Use only in well-ventilated area. Wash thoroughly after handling.

Storage: Keep out of direct sun light and from freezing.

Section 8: Exposure Controls and Personal Protection

Engineering Controls:

Local Exhaust: Provide sufficient mechanical (general and/or local exhaust) ventilation to maintain exposure below TLV(s).

General exhaust: Recommended

Personal Protective Equipment for Routine Handling:

Eyes: Use proper protection – safety glasses as needed.

Skin: Washing at meal time and end of shift is adequate.

Suitable Gloves: butyl rubber protection gloves as needed

Inhalation: If spraying or other operations that generate an aerosol mist are conducted, respiratory protection for exposed personnel is recommended.

Precautionary Measures: Avoid eye contact.

Section 9: Physical and Chemical Properties:

Physical Form:	Liquid	Viscosity:	Not determined
Color:	milky	Melting Point:	Not determined
Odor:	Slight	Boiling Point:	Not determined
Specific Gravity @ 25C:	~1	Flash Point:	Not Applicable
Solubility in Water:	Soluble	Vapor Pressure	Not determined
VOC content (% by weight)	< 0.5%	pH:	~6-8

Section 10: Stability and Reactivity

Chemical Stability: Stable at room temperature and under normal conditions

Hazardous Polymerization: Will not polymerize

Conditions to Avoid: Avoid heat, sparks, open flames and other sources of ignition.

Materials to Avoid: Strong oxidizing agents.

Hazardous Decomposition Products: Carbon oxides.

Section 11: Toxicological Information

Information on likely routes of exposure

Inhalation No adverse effects due to inhalation are expected.

Skin contact Causes skin irritation. May cause an allergic skin reaction.

Eye contact Causes serious eye damage.

Ingestion Expected to be a low ingestion hazard.

Acute toxicity Not known.

Section 12: Ecological Information

Ecotoxicity: Not regarded as dangerous for the environment. However, large or frequent spills may have hazardous effects on the environment.

Toxicity: Based on available data the classification criteria are not met.

Persistence and degradability: The degradability of the product is not known.

Bioaccumulative potential Bio-Accumulative Potential: No data available on bioaccumulation.

Partition coefficient Not determined.

Mobility in soil: Mobility No data available.

Other adverse effects: Other adverse effects None known

*Expected to be readily biodegradable without adverse effects.

Section 13: Disposal Considerations

Disposal instructions Collect and reclaim or dispose in sealed containers at licensed waste disposal site. Do not allow this material to drain into sewers/water supplies. Do not contaminate ponds, waterways or ditches with chemical or used container. Dispose of contents/container in accordance with local/regional/national/international regulations.

Local disposal regulations Dispose in accordance with all applicable regulations.

Hazardous waste code The waste code should be assigned in discussion between the user, the producer and the waste disposal company.

Waste from residues / unused products Dispose of in accordance with local regulations. Empty containers or liners may retain some product residues. This material and its container must be disposed of in a safe manner (see: Disposal instructions).

Contaminated packaging Since emptied containers may retain product residue, follow label warnings even after container is emptied. Empty containers should be taken to an approved waste handling site for recycling or disposal..

Section 14: Transportation Information

DOT Not regulated as dangerous goods

IATA Not regulated as dangerous goods.

IMDG Not regulated as dangerous goods.

Section 15: Regulatory Information

US federal regulations

Superfund Amendments and Reauthorization Act of 1986 (SARA)

SDS- Truly Premium Advance Auto Wash

Compare products